Pen Master ACCU-CUT chisel set

Pen Master ACCU-CUT carbide chisel set with square rougher and round finisher. Includes:

1x roughing chisel with 10.5 mm square carbide cutter
1x finishing chisel with 11.9 mm round carbide cutter
2x M4-40 x 5/16 screws
2x Allen wrenches

Canadian-made stainless steel tool bar with solid plastic handle. These tools have smaller cutters and are lighter than the regular Pen Master carbide tools. NOTE: Pen Master ACCU-CUT is not compatible with regular Pen Master carbide tools.

Stainless steel tool bar: 89 mm long x 9.5 mm square
Plastic handle:  215 mm long
Cutters: 11.9 mm round and 10.5 mm square
Screw: M4-40 x 5/16
Weight: 0.240 kg

Usage and safety information:

• These tools come with replaceable carbide cutters. Simply rotate the cutter when one side gets dull. When you've used all the sides, just replace with a new cutter or use a Trend diamond sharpening stone with lapping fluid to sharpen. Do not use dull cutters – not only will the tool not work properly, but it can also be a safety hazard.
• Set tool rest height so the top of the cutter aligns with the centre of the spindle.
• Hold the tool flat on the tool rest and parallel to the floor. 
• Don’t force the tool to cut. Light, slow cuts work best. These tools are very sharp and can dig into the blank if too much pressure is applied.
• Make sure the blank you are working on is secured properly and tightly.
• Wear safe and protective clothing as well as safety glasses and/or a face shield and use a dust mask when necessary.
• Read and understand your lathe’s owner’s manual.

Price per chisel in Canadian dollars.